A-One Engg. Works

Component :

SS316L, 5 liter Pressure Vessel with vent – valve and a special extended outlet connection to fit capsules with 1/4″ MNPT Inlet

Technical Parameters :
Capacity: 5ltr , 10ltr , 20Ltr ,50Ltr
Vessel: MOC SS 316L
O-Ring: Seal Silicon
Inlet Connection: 1⁄4 ( BSPF) , 1.5” TC

Oil Free Vacuum Pump 15 LPM
Glass Flask 1L
Stainless Steel Filter Holder 300ml
Membrane Filter 47mm x 0.45um Cellulose Nitrate
SS Forceps

Product Description:

Apply a concentrated jet spray of ultra cleaned solvent of rinse solution to surfaces that require washing. Just connect the Filter Jet dispenser to a dispensing vessel to ensure that the solvent or other liquid is filtered immediately before dispensing.

Applications:

Solvent Filtration Prior to Contamination Analysis, Solvent Rinsing of Machined Parts and Collection Containers Stainless steel filter holder and filter support screens; Polypropylene Handle dispenser; PTFE valve; polyethylene pressure tubing; stainless steel jet nozzle 0.5mm

• Description

Dispensing Pressure Vessels & Filtering Jet Gun – Dispensing Pressure Vessels hold liquid for filtration through pressure-operated filter holders. Apply a concentrated jet spray of ultra cleaned solvent of rinse solution to surfaces that require washing. Just connect the Filtering Jet Gun to a dispensing vessel to ensure that the solvent or other liquid is filtered immediately before dispensing.

Applications:

Solvent Filtration Prior to Contamination Analysis, Solvent Rinsing of Machined Parts and Collection Containers Stainless steel filter holder and filter support screens; Polypropylene Handle dispenser; PTFE valve; polyethylene pressure tubing; stainless steel jet nozzle 0.5mm

Container Closure Integrity Testing (CCIT), commonly referred to as leak detection, is a non-destructive packaging inspection system to maintain an aseptic barrier against potential contaminants.Testing MethodsThe deterministic methods include the following:Electrical Conductivity and Capacitance Test (HVLD)Laser-based Gas Headspace Analysis.Mass Extraction.Pressure Decay.Tracer Gas (vacuum mode)Vacuum/ pressure Decay.
*Why Container Closure Testing is important:
CCIT detects defects that demonstrate breach of the container and/or closure system.
-Patient and consumer health and safety is the principal reason why testing methods are put into place. Product sterility and consumer safety begins at the product development phase by evaluating the suitability of primary packaging in its ability to offer a sterile barrier thanks to its container closure system which should not result in contamination or leaks of the drug or product.
Other than the leak test method and positive and negative sampling, which should be sufficient enough to provide adequate assurance of package integrity (USP <1207.1>), the criteria for acceptance must also be determined and accordingly all negative controls should pass while all positives must fail.